BriskHeat SpeedTrace heating cables are an ideal solution for easy-to-install pipe freeze protection and safe thawing of metal and plastic pipe & valve assemblies. May be used on metal and plastic water pipes, for pipe heating, but not on flexible vinyl tubing (such as garden hoses). BriskHeat SpeedTrace heating cable self-regulates the pipe heating cables temperature by automatically adjusting electric cable heat output based on surface and ambient temperatures. Plug-and-Play easy to install pipe heating solution! No electrical work! No electrician!
SpeedTrace Extreme: 8 watts/ft (26 watts/m) at 50°F (10°C)
Automatically adjusts heat output based on surface and ambient temperatures
No temperature controller is required
Plug-in ready pre-assembled power cord
Grounded design for added safety
Suitable for extreme cold conditions as low as -40°F (-40°C)
Safe for indoor and outdoor use
Safe to overlap heating cable for easy installation
Use with INSUL-LOCK DS foam insulation for maximum thermal efficiency
BriskHeat SpeedTrace heating cables are an ideal solution for easy-to-install pipe freeze protection and safe thawing of metal and plastic pipe & valve assemblies. May be used on metal and plastic water pipes, for pipe heating, but not on flexible vinyl tubing (such as garden hoses). BriskHeat SpeedTrace heating cable self-regulates the pipe heating cables temperature by automatically adjusting electric cable heat output based on surface and ambient temperatures. Plug-and-Play easy to install pipe heating solution! No electrical work! No electrician!
SpeedTrace Extreme: 8 watts/ft (26 watts/m) at 50°F (10°C)
Automatically adjusts heat output based on surface and ambient temperatures
No temperature controller is required
Plug-in ready pre-assembled power cord
Grounded design for added safety
Suitable for extreme cold conditions as low as -40°F (-40°C)
Safe for indoor and outdoor use
Safe to overlap heating cable for easy installation
Use with INSUL-LOCK DS foam insulation for maximum thermal efficiency
from BriskHeat
Automatically adjusts heat output based on surface and ambient temperatures
No temperature controller is required
Plug-in ready pre-assembled power cord
Grounded design for added safety
Suitable for extreme cold conditions as low as -40°F (-40°C)
Safe for indoor and outdoor use
Safe to overlap heating cable for easy installation
Use with INSUL-LOCK DS foam insulation for maximum thermal efficiency
How Self-Regulating BriskHeat SpeedTrace Heating Cable Works
The semi-conductive core material contains a graphite network, which allows electricity to flow from one bus wire to the other. When the core is dense and colder, there are many paths for electricity to take through the graphite network, producing more heat.
Since the core material expands as it heats, the graphite network is elongated, disrupting some of the paths. More and more paths are disrupted as heating continues until the system reaches self-controlled thermal stability. When the core material cools, it contracts, reconnecting some of the electrical paths in the graphite network, and more equivalent heat is produced.
This temperature response occurs independently at each point along the heater. If an externally produced high temperature occurs next to a low temperature in the cable, each section of heating cable will adjust its own heat output in relation to its own local requirements.